They are RFC 1918 addresses that are used in a lab environment. The IP address schemes used in this configuration are not legally routable on the Internet. This section provides information used to configure the packet capture features that are described in this document. In addition, it is possible to create multiple captures in order to analyze different types of traffic on multiple interfaces. The packet capture process is useful to troubleshoot connectivity problems or monitor suspicious activity. This document describes how to configure the Cisco Adaptive Security Appliance (ASA) Next-Generation Firewall in order to capture the desired packets with either the Cisco Adaptive Security Device Manager (ASDM) or the Command Line Interface (CLI) (ASDM). This configuration is also used with these Cisco products: If your network is live, ensure that you understand the potential impact of any command. All of the devices used in this document started with a cleared (default) configuration. The information in this document was created from the devices in a specific lab environment. This document is not restricted to specific hardware or software versions. This procedure assumes that the ASA is fully operational and is configured in order to allow the Cisco ASDM or the CLI to make configuration changes. This document describes how to configure the Cisco ASA firewall to capture the desired packets with the ASDM or the CLI.

How to use wireshark to get ip inbound